The tension on my singer touch tronic 2010 is always messed up. ?
How I adjust the bobbin tension on touch tronic 2010, it changes on its own constantly; either too loose or knots. Also rubber pressure feet do not feed very well, much pull on starter treads very hard for initial stitches or grabs material and pulls down into bobbin case.Dee
Hello Dee,
The teflon feet were always a waste of time and I don't thnk you can change them but I will give you an email address where you may be able to get proper teeth.
There is a screw on the bobbin case, turn the screw anti clockwise about a quarter of a turn and test until you get it right, remember that Singer machines usually only work perfectly with mercerised thread, this site no longer allows email addresses to be shown so follow these instructions, the site you want is tandtrepair put www. in front of it, then . then com
Ken
Information posted by users should be considered for general guidance only. Users act, or refrain from action, on the basis of such information entirely at their own risk.
fixed4free.com does not endorse any of the information supplied on this website by users.