|
|
|
|
|
|
|
|
I have a Jones 641 sewing machine and I am unable to wind a bobbin correctl?I can loosen the stop motion knob, however when I wind a new bobbin the needle on the machine still continues to move up and down through the plate.
Gemma January 2010
|
|
|
Click here if you can answer this question |
|
|
|
|
|
Hello Gemma,
The top shaft near the balance wheel is dry, take the belt off, take out the screw in the stop motion wheel, unscrew the stop motion wheel all the way off, take off the three pronged washer and notice which way you have the washer off, pull the balance wheel partway or all the way off, you can now see the top shaft, get some fine oil such as WD40 and oil the shaft, put everything back, make sure you screw the stop motion so it is finger tight then tighten the screw, also take the top off the machine and put a couple of drops of oil on the bobbin winder shaft otherwise eventually it will seize up because of the high speed.
Ken
drivewithken January 2010 |
|
|
|
|
|
|
|
|
Add your answer using the form below ...
|
|
|
|
|
|
|
|
|
|
|