hi there, i have a scantronic 9600 alarm system with 2 keypads, 2 door contacts, 4 pir detectors, 16 ohm speaker, and a texecom oddyssey 3. to cut to the chase the 2 keypads draw 45ma each and the 4 pirs draw 14ma each and the oddysey draw 523ma in total and the speaker probably 100ma the total current is 767 ma. reading the manual the system output current is 1250ma is this meaning the aux circuit for the detectors or the whole system or does each output have its own current. also what is the bell output current for the panel it doesn,t say im guesing an 1amp?
the 9600 panel total load is 1250ma your in no danger of overloading the panel, as for the bell output its 1amp im guessing, ive put 680ma on it and its fine. just bear in mind the load of your detectors communicators ect
Information posted by users should be considered for general guidance only. Users act, or refrain from action, on the basis of such information entirely at their own risk.
fixed4free.com does not endorse any of the information supplied on this website by users.