F01 error code indicates a fault in the motor triac.
This can be a fault in the motor and/or the main control board.
The service manuals suggests the following:-
Check for continuity of motor (Field coil pins 3-5 and armature pins 1-2);
Check efficiency of module connector block J9, motor terminal block and wiring between motor and edge connector J9;
Unplug the appliance.
Take the rear panel off.
The main board is bottom left when viewed from the rear.
Take the board out.
Take the plugs off and plug them on again to ensure they are clean, dry and tight fitting.
Check the circuit board for any obvious damage.
Check the motor plug and wiring.
If everything checks ok, I'm afraid you'll likely need a new board, possibly a motor too, and the board will need to be programmed to the appliance after fitting, a task for a professional i imagine.
Information posted by users should be considered for general guidance only. Users act, or refrain from action, on the basis of such information entirely at their own risk.
fixed4free.com does not endorse any of the information supplied on this website by users.